STX Coilovers ST Suspensions AUDI A4 B7 Cabriolet / Quattro B7

Years: 11/00-

Maximum permitted front axle load (in kg): -1080

Maximum permitted rear axle load (in kg): -1165

Front lowering in mm: 35-65

Rear lowering in mm: 35-60

Derived from motorsport, the STX range allows ultra-precise ride height adjustment while benefiting from a factory-set fixed damping setting. Ride height adjustment at the front and rear (where the vehicle allows) via a dial located on the threaded body of the shock absorber. Hot-dip galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if you only have original springs at the rear, the same will apply with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please remember to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut tubes are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Please contact us using the contact form for any further information.

Technical note to consider before ordering:

EXCEPT 4WD.

EXCEPT models equipped with ride level control (or ride level control adjustment required).