Threaded coilovers ST Suspensions AUDI A4 B8 / A4 Quattro B8 / A5 Cabriolet / A5 Coupé / A5 Quattro Sportback

Years: 11/07-09/15

Maximum permitted front axle load (in Kg): -1080

Maximum permitted rear axle load (in Kg): -1245

Front lowering in mm: 25-55

Rear lowering in mm: 25-50

Derived from motorsport, the STX range offers ultra-precise ride height adjustment while benefiting from a factory-set fixed damping rating. Ride height adjustment on the front and rear (where the vehicle allows) via a disc located on the threaded body of the shock absorber. Galvanized finish and anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to fit the vehicle. They replace the original suspension without modification. For example, if the vehicle only has springs at the rear as standard, the same will apply to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any further information, please use our contact form.

Technical note to consider before ordering:

EXCEPT 4WD.

EXCEPT models equipped with ride height correction (or ride height correction adjustment required).

For vehicles equipped with electronically controlled suspension, make sure it is disconnected. A disconnection kit can be found in the KW accessories range, REF 68510144.