STXTA Coilovers ST Suspensions VOLKSWAGEN Scirocco

STXTA Coilovers ST Suspensions for VOLKSWAGEN Scirocco, (13) R

Years: 12/09-

Maximum permitted front axle load (kg): 1001-1090

Maximum permitted rear axle load (kg): -780

Front lowering in mm: 10-45

Rear lowering in mm: 10-45

Derived from motorsport, the STX-TA range offers ultra-precise ride height adjustment along with damping adjustment. Ride height can be adjusted at the front and rear (where the vehicle allows it) via a collar on the threaded body of the shock. They are supplied with adjustable aluminum top mounts for precise camber adjustment to suit your needs. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any further information, please contact us using the contact form.

Technical note to consider before ordering:

FOR models with a 55mm diameter strut on the front axle.

With maximum lowering, the turn signals and parking lights must be relocated (ride height too low for TÜV, STVZ0 standard)

For vehicles equipped with DDC electronically controlled suspension, make sure it is disconnected. A disconnection kit is available in the KW accessories range (REF 68510141)