STXTA Coilovers ST Suspensions VOLKSWAGEN Golf VI

STXTA coilovers by ST Suspensions for VOLKSWAGEN Golf VI, (1K) Ø 55mm struts

Years: 10/08-

Maximum permitted front axle load (in kg): 1106-1170

Maximum permitted rear axle load (in kg): -1000

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX-TA range offers ultra-precise height adjustment along with damping adjustment. Height adjustment on the front and rear (where the vehicle allows it) is made via a disc located on the threaded body of the shock absorber. They are supplied with adjustable aluminum strut mounts to also allow precise camber adjustment to suit your needs. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in quantities sufficient to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

EXCEPT 4WD.

FOR models with 55mm diameter strut on the front axle.

For vehicles equipped with DDC electronically controlled suspension, make sure it is disconnected. You can find a disconnect kit in the KW accessory range, REF 68510141.