STXTA Coilovers ST Suspensions VOLKSWAGEN Golf IV 4Motion

STXTA ST Suspensions coilovers for VOLKSWAGEN Golf IV, (1J) R32

Years: 09/02-

Maximum permitted front axle load (in kg): -1110

Maximum permitted rear axle load (in kg): -1080

Front lowering in mm: 10-40

Rear lowering in mm: 10-35

Derived from motorsport, the STX-TA range allows ultra-precise height adjustment along with damping adjustment. Height adjustment on the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. They are supplied with adjustable aluminum strut mounts to also allow precise camber adjustment according to your needs. Galvanized treatment plus anti-corrosion coating for extended service life.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has springs at the rear, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. Strut assemblies are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

For any other information, please feel free to contact us using the contact form.

Technical note to consider before ordering:

Fitting may require wheel spacers.