STXTA Coilovers ST Suspensions VOLKSWAGEN Golf III Convertible

STXTA Coilovers by ST Suspensions for VOLKSWAGEN Golf III / Vento, (1HX0,1H,1EX0,1E) 2WD, Sedan, Convertible

Years: 09/91-

Maximum permitted front axle weight (in kg): 891-980

Maximum permitted rear axle weight (in kg): -880

Front lowering in mm: 45-80

Rear lowering in mm: 45-80

Derived from motorsport, the STX-TA range offers ultra-precise height adjustment along with damping adjustment. Height adjustment at the front and rear (on vehicles that allow it) is made via an adjustment ring located on the threaded body of the shock absorber. They come with adjustable aluminum strut mounts for precise camber adjustment to suit your needs. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They replace the original suspension without modification. For example, if the original setup only has rear springs, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut assemblies are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

EXCEPT 4WD vehicles.

Installation may require wheel spacers.