STXTA Coilovers ST Suspensions VOLKSWAGEN Bora

STXTA coilovers from ST Suspensions for VOLKSWAGEN Bora, (1J) two-wheel drive, Sedan, Wagon

Years: 10/98-

Maximum permitted front axle load (in Kg): -1020

Maximum permitted rear axle load (in Kg): -1080

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX-TA range offers ultra-precise height adjustment along with damping adjustment. Height adjustment on the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. They are supplied with adjustable aluminum strut mounts to also allow precise camber adjustment according to your needs. Galvanized finish + anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original equipment only has springs at the rear, this will also be the case with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

EXCEPT 4-wheel drive.

Installation may require wheel spacers.

For 50mm diameter models, it is strongly recommended to replace the original sway bar to avoid contact with the right-hand axle shaft. Use sway bar 66550008 (to be ordered separately). (91)