STXTA Coilovers ST Suspensions SEAT Toledo II / SKODA Octavia I / VOLKSWAGEN Bora / VOLKSWAGEN Golf IV

STXTA coilovers ST Suspensions for SEAT Toledo, (1M)

Years: 04/99-

Maximum permitted front axle load (kg): -1020

Maximum permitted rear axle load (kg): -1020

Front lowering (mm): 35-65

Rear lowering (mm): 35-65

Derived from motorsport, the STX-TA range offers ultra-precise height adjustment combined with damping adjustment. Height adjustment at the front and rear (on vehicles that allow it) is made via a ring located on the threaded body of the shock absorber. They are supplied with adjustable aluminum strut mounts for precise camber adjustment to suit your needs. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has rear springs, the same will apply to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut assemblies are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

Installation may require wheel spacers.

For models with a 50 mm diameter, it is strongly recommended to replace the original sway bar to avoid any contact with the right-side axle shaft. Use sway bar 66550008 (ordered separately). (91)

In case of extreme lowering, it is strongly recommended to replace the sway bar to avoid any contact with the right-side axle shaft. For versions without Xenon headlights, use sway bar REF. 685 50 000. For versions with Xenon headlights, use sway bar REF. 685 50 005.