STXTA Coilovers ST Suspensions BMW 3 Series

STXTA coilovers by ST Suspensions for BMW 3 Series (E46), (346L, 346C, 346R) Sedan, Touring, Coupe, Convertible

Years: 05/98-

Maximum permitted front axle weight (in Kg): -910

Maximum permitted rear axle weight (in Kg): -1215

Front lowering in mm: 40-75

Rear lowering in mm: 30-60

Derived from motorsport, the STX-TA range offers ultra-precise height adjustment along with damping adjustment. Height adjustment on the front and rear (where the vehicle allows) is made via a ring located on the threaded body of the shock absorber. They are supplied with adjustable aluminum top mounts to also allow precise camber adjustment according to your needs. Galvanized finish plus anti-corrosion coating for extended longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They install in place of the original suspension, without modification. For example, if your vehicle only has springs at the rear as original equipment, the same applies with these ST Suspensions kits.

The only models sold with top mounts are the STXTA coilovers. For any other model, please make sure to fit original top mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut assemblies are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any further information, please use our contact form.

Technical note to consider before ordering:

EXCEPT 4WD vehicles.

Installation may require wheel spacers.