STXTA Coilovers ST Suspensions AUDI A3 / AUDI TT 8N Coupé / SEAT Leon I / VOLKSWAGEN Golf IV

STXTA coilovers ST Suspensions for AUDI A3, (8L) 2WD

Years: 09/96 onward

Maximum permitted front axle weight (kg): -1020

Maximum permitted rear axle weight (kg): -1025

Front lowering in mm: 30-70

Rear lowering in mm: 30-70

Derived from motorsport, the STXTA range allows ultra-precise height adjustment along with damping adjustment. Height adjustment at the front and rear (where the vehicle allows) is made via a disc located on the threaded body of the shock absorber. Supplied with adjustable aluminum strut mounts for precise camber setting as needed. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies with these ST Suspensions kits.

The only models supplied with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Strut legs are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Please use our contact form for any further information.

Technical note to consider before ordering:

Fitting may require wheel spacers.

For 50mm diameter models, it is strongly recommended to replace the original sway bar to avoid any contact with the right-hand driveshaft: use sway bar 66550008 (to be ordered separately). (91)

For extreme lowering, it is strongly recommended to replace the sway bar to avoid any contact with the right-hand driveshaft. For versions without Xenon headlights, use sway bar REF. 685 50 000. For versions with Xenon headlights, use sway bar REF. 685 50 005.