STXA Threaded Coilovers ST Suspensions VOLKSWAGEN Passat CC 4-Motion

Years: 04/07-

Maximum permitted front axle load (in kg): -1180

Maximum permitted rear axle load (in kg): -1230

Front lowering in mm: 15-45

Rear lowering in mm: 15-45

Derived from motorsport, the STXA range offers adjustment of both height AND damping. Height adjustment at front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive dial located at the top of the shock absorber rod. For those who need to fine-tune their settings to achieve a personalized "setup". Galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if your vehicle only has springs at the rear from the factory, the same will apply with these ST Suspension kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspension kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Please feel free to contact us via the contact form for any further information.

Technical note to consider before ordering:

FOR models with 55mm strut diameter on the front axle.

For vehicles equipped with DDC electronically controlled suspension, make sure it is properly disconnected. You can find a disconnection kit in the KW accessories range, REF 68510141,