STXA threaded coilovers ST Suspensions SKODA Octavia III

Years: 02/13-

Maximum permitted front axle weight (kg): -925

Maximum permitted rear axle weight (kg): -1050

Front lowering (mm): 35-65

Rear lowering (mm): 35-65

Motorsport-derived, the STXA range offers adjustment of both ride height and damping. Ride height adjustment at the front and rear (where the vehicle allows it) is made by a disc located on the threaded body of the shock absorber. Very precise damping adjustment is made by a progressive dial at the top of the shock absorber shaft. For those who need to fine-tune their setup for a personalized setup. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup has only rear springs, the same applies with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

Please use our contact form for any other information.

Technical note to consider before ordering:

On M-Tech equipped models, only use lowering spring kits. Lowering will be 20 mm less than the value indicated

FOR models with a 50 mm diameter strut on the front axle.