STXA threaded coilovers ST Suspensions SEAT Leon III

Years: 11/13-

Maximum permitted front axle load (Kg): 966-1090

Maximum permitted rear axle load (Kg): -1050

Front lowering (mm): 35-65

Rear lowering (mm): 35-65

Derived from motorsport, the STXA range allows adjustment of both height AND damping stiffness. Height adjustment at the front and rear (where the vehicle allows it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber rod. For anyone who needs to fine-tune their setup for a personalized configuration. Galvanized treatment and anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential to lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please use our contact form.

Technical note to consider before ordering:

FOR models with Ø 55mm strut diameter on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.