STXA ST Suspensions Coilovers for VOLKSWAGEN Golf VII 4Motion

STXA threaded coilovers by ST Suspensions for VOLKSWAGEN Golf VII, (AU) Sedan, all-wheel drive, models with independent rear suspension (IRS), Ø 50mm struts

Years: 11/12-

Maximum permitted front axle load (kg): 966-1080

Maximum permitted rear axle load (kg): -980

Front lowering (mm): 35-65

Rear lowering (mm): 40-65

Derived from motorsport, the STXA range offers adjustment of both ride height AND damping. Ride height adjustment on the front and rear (where the vehicle allows) via a disc located on the threaded shock body. Very precise damping adjustment via a progressive knob located at the top of the shock shaft. For anyone who needs to fine-tune their setup to dial in a personalized configuration. Galvanized treatment plus anti-corrosion coating for extended longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They install in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as original equipment, the same will apply with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to use original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut bodies are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Please use the contact form for any further information.

Technical note to consider before ordering:

ON M-Tech equipped models, only use lowering springs. The lowering will be 20mm less than indicated

FOR models with 50mm strut diameter on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.