STXA Coilovers ST Suspensions VOLKSWAGEN Jetta VI

Years: 01/11-

Maximum permitted front axle load (in kg): 1016-1060

Maximum permitted rear axle load (in kg): -1150

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STXA range offers adjustable ride height AND damping stiffness. Ride height adjustment at front and rear (where the vehicle allows) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber shaft. For those who need to fine-tune their setup for a personalized configuration. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as standard, the same will apply to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any other information, please use our contact form.

Technical note to consider before ordering:

EXCEPT 4WD vehicles.

FOR models with a 55mm diameter strut on the front axle.