STXA Coilovers ST Suspensions VOLKSWAGEN Golf VI

Years: 10/08-

Maximum permitted front axle load (in Kg): 1106-1170

Maximum permitted rear axle load (in Kg): -1000

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STXA range allows adjustment of ride height AND damping stiffness. Ride height can be adjusted at the front and rear (where the vehicle allows) via a ring located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber shaft. For anyone who needs to fine-tune their setup and run a personalized "setup". Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has springs at the rear, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut bodies are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Please feel free to contact us via the contact form for any further information.

Technical note to consider before ordering:

EXCEPT 4WD vehicles.

FOR models with 50mm strut diameter on the front axle.

For vehicles fitted with DDC electronically controlled suspension, make sure it is disconnected. A disconnection kit, KW ref. 68510141, is available in the KW accessory range.