STXA Coilovers ST Suspensions VOLKSWAGEN Golf IV

Years: 04/99-

Maximum permitted front axle load (kg): -1020

Maximum permitted rear axle load (kg): -1080

Front lowering (mm): 35-65

Rear lowering (mm): 35-65

Derived from motorsport, the STXA range allows adjustment of BOTH height AND damping. Height adjustment at the front and rear (on vehicles that allow it) via a disc on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob at the top of the shock absorber rod. For those who need to fine-tune their settings for a personalized "setup". Galvanizing plus anti-corrosion coating for extended durability.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has springs at the rear, the same will apply with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. Strut legs are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any further information, please do not hesitate to contact us using the contact form.

Technical note to consider before ordering:

EXCEPT 4WD.

Fitting may require wheel spacers.

For 50mm diameter models, it is strongly recommended to replace the original sway bar to avoid contact with the right-hand driveshaft; use sway bar 66550008 (to be ordered separately). (91)