STXA Coilovers ST Suspensions VOLKSWAGEN Golf III Syncro

Years: 01/93-

Maximum permitted front axle load (in Kg): -980

Maximum permitted rear axle load (in Kg): -990

Front lowering in mm: 45-80

Rear lowering in mm: 45-80

Derived from motorsport, the STXA range allows adjustment of BOTH height AND damping. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber rod. For those who need to fine-tune their "setup" to achieve a personalized configuration. Galvanized finish + anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as standard, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please remember to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Please contact us via the contact form for any other information.

Technical note to consider before ordering:

Installation may require wheel spacers.