STXA Coilovers ST Suspensions VOLKSWAGEN Bora

Years: 10/98-

Maximum permitted front axle weight (in kg): -1020

Maximum permitted rear axle weight (in kg): -1080

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STXA range offers height AND damping adjustment. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock rod. For everyone who needs to fine-tune their setup to achieve a personalized "setup." Galvanized finish plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if you only have rear springs as original equipment, the same will apply to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut assemblies are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to take into account before ordering:

EXCEPT 4WD.

Installation may require wheel spacers.

For 50mm diameter models, it is strongly recommended to replace the original sway bar to avoid any contact with the right-hand axle shaft. Use sway bar 66550008 (to be ordered separately). (91)