STXA Coilovers ST Suspensions SEAT Leon I

Years: 11/99-

Maximum permitted front axle weight (kg): -1020

Maximum permitted rear axle weight (kg): -1020

Front lowering (mm): 35-65

Rear lowering (mm): 35-65

Derived from motorsport, the STXA range allows adjustment of BOTH ride height AND damping. Height adjustment at the front and rear (where the vehicle allows it) via a collar on the threaded body of the shock absorber. Very precise damping adjustment via a progressive dial at the top of the shock absorber shaft. For those who need to fine-tune their setup to dial in a personalized configuration. Galvanized finish + anti-corrosion coating for increased longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has rear springs as original equipment, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspension kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

Installation may require wheel spacers.

For 50 mm diameter models, it is strongly recommended to replace the original sway bar to avoid contact with the right-hand driveshaft: use sway bar 66550008 (to be ordered separately). (91)

For extreme lowering, it is strongly recommended to replace the sway bar to avoid contact with the right-hand driveshaft. If the version has no Xenon headlights, use sway bar REF. 685 50 000; if the version has Xenon headlights, use sway bar REF. 685 50 005