STXA Coilovers ST Suspensions MINI MINI

Years: 03/12-

Maximum permitted front axle load (in kg): -860

Maximum permitted rear axle load (in kg): -630

Front lowering (in mm): 25-50

Rear lowering (in mm): 30-60

Derived from motorsport, the STXA range allows adjustment of both height AND damping. Height adjustment at the front and rear (on vehicles that allow it) is made by a disc located on the threaded body of the shock absorber. Very precise damping adjustment is made with a progressive knob located at the top of the shock absorber rod. For anyone who needs to fine-tune their settings to get a personalized setup. Galvanized finish plus anti-corrosion coating for extended service life.

The STXA coilovers from ST Suspensions are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have springs at the rear as original equipment, the same applies with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any other information, please contact us using the contact form.

Technical note to consider before ordering:

Fitting may require wheel spacers.