STXA Coilovers ST Suspensions BMW 5 Series

Years: 12/95-

Maximum permitted front axle weight (in kg): -1020

Maximum permitted rear axle weight (in kg): -1200

Front lowering in mm: 35-65

Rear lowering in mm: 30-60

Derived from motorsport, the STXA range allows adjustment of both height AND damping stiffness. Height adjustment on the front and rear (on vehicles that allow it) via a ring located on the threaded body of the shock. Very precise stiffness adjustment via a progressive knob located at the top of the shock rod. For anyone who needs to fine-tune their setup for a personalized "setup." Galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has springs at the rear, this will also be the case with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential to lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

We remain available via the contact form for any further information.

Technical note to consider before ordering:

EXCEPT models equipped with a ride height corrector (or ride height corrector adjustment required).

For models equipped with the EDC system (electronic damping control)

the following parts must be replaced: Front: bearing: REF. BMW 31 331 091 709 + strut mount: REF. BMW 31 331 116 983 + dust boot: REF. BMW 31 331 110 196. Rear: upper bearing REF. BMW 33 521 091 710 + bracket: REF BMW 33 521 090 282 + spring seat: REF BMW 33 521 092 986 + dust boot: REF BMW 31 331 137 932 + rubber washer: REF BMW 33 531 091 031.