STXA coilovers ST Suspensions BMW 3 Series

Years: 02/12-

Maximum permitted front axle load (in kg): -950

Maximum permitted rear axle load (in kg): -1230

Front lowering in mm: 40-65

Rear lowering in mm: 30-60

Derived from motorsport, the STXA range allows adjustment of BOTH height AND damping. Height adjustment on front and rear (where the vehicle allows it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber shaft. For those who need to fine-tune their setup for a personalized "setup". Galvanized finish + anti-corrosion coating for increased longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have original springs at the rear, this will also be the case with these ST Suspensions kits.

The only models sold with strut mounts are the STXA threaded coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut tubes are galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

ON models equipped with M-Tech, use only the lowering springs. Lowering will be 20 mm less than indicated