STXA Coilovers ST Suspensions BMW 1 Series

Years: 03/08 onward

Max. permitted front axle weight (kg): up to 960

Max. permitted rear axle weight (kg): up to 1115

Front lowering (mm): 30-55

Rear lowering (mm): 25-50

Derived from motorsport, the STXA range allows adjustment of both ride height AND damping stiffness. Ride height is adjustable at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber shaft. For those who need to refine their settings to achieve a personalized "setup". Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has springs at the rear, the same will apply to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please use the contact form.

Technical note to consider before ordering:

EXCEPT 4-wheel drive models.

Installation may require wheel spacers.