STXA Coilovers ST Suspensions AUDI TT 8J Coupé

Years: 09/06-09/14

Maximum permitted axle load front (in kg): -965

Maximum permitted axle load rear (in kg): -870

Front lowering in mm: 20-50

Rear lowering in mm: 20-50

Derived from motorsport, the STXA range allows adjustment of BOTH height AND damping. Height adjustment at the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob at the top of the shock absorber rod. For everyone who needs to fine-tune their setup to get a personalized "setup". Galvanized treatment + anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have original springs at the rear, the same will apply with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

Please use the contact form for any other information.

Technical note to consider before ordering:

FOR models with 55mm diameter strut on the front axle.

For vehicles fitted with Audi Magnetic Ride, make sure it is properly disconnected. You can find in the KW accessory range REF 68510124, a disconnection kit.