STXA Coilovers ST Suspensions AUDI A3 / S3

STXA ST Suspensions coilovers for AUDI A3, (8V) without adaptive suspension, sedan + Sportback, all-wheel drive, 55 mm strut diameter, models with independent rear suspension (IRS)

Years: 05/12-

Maximum permitted front axle weight (kg): -1100

Maximum permitted rear axle weight (kg): -1040

Front lowering (mm): 30-60

Rear lowering (mm): 30-55

Derived from motorsport, the STXA range allows adjustment of BOTH ride height AND damping. Ride height adjustment at the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber rod. For everyone who needs to fine-tune their setup for a personalized setup. Hot-dip galvanized treatment plus anti-corrosion coating for increased longevity.

The ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have original rear springs, the same applies with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

ON models fitted with M-Tech, only use lowering springs. The lowering will be 20mm less than indicated

FOR models with 55mm strut diameter on the front axle.

For vehicles fitted with adaptive suspension, the disconnect box is required. Part number 68510370