STXA Coilovers ST Suspensions AUDI A3 Cabriolet / AUDI A3 Quattro / AUDI S3 / VOLKSWAGEN Touran I

Years: 04/08-

Maximum permitted front axle load (in kg): 1106-1170

Maximum permitted rear axle load (in kg): -1160

Front lowering in mm: 25-55

Rear lowering in mm: 25-55

Derived from motorsport, the STXA range allows adjustment of both height AND damping stiffness. Height adjustment at the front and rear (where the vehicle allows it) via a disc on the threaded body of the shock. Very precise damping adjustment via a progressive dial at the top of the shock rod. For anyone who needs to fine-tune their setup to get a personalized setup. Galvanized finish + anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has rear springs, the same applies with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

FOR models with 55mm diameter strut on the front axle.

For vehicles equipped with DDC controlled suspension, make sure it is properly disconnected. You can find in the KW accessory range REF 68510141, a disconnection kit