STXA Coilovers ST Suspensions AUDI A3

STXA coilovers by ST Suspensions for AUDI A3, (8V) without electronically controlled suspension, incl. Sedan + Sportback, 2WD, models with independent rear suspension (IRS) struts Ø 55mm

Years: 05/12-

Maximum permitted front axle load (in Kg): 981-1075

Maximum permitted rear axle load (in Kg): -990

Front lowering in mm: 30-60

Rear lowering in mm: 30-55

Derived from motorsport, the STXA range allows adjustment of both ride height AND damping stiffness. Height adjustment on the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber rod. For those who need to fine-tune their setup to achieve a personalized "setup". Galvanized finish plus anti-corrosion coating for extended longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original car only has springs at the rear, the same will apply with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please contact us via the contact form.

Technical note to consider before ordering:

On M-Tech equipped models, only use the lowering spring kits. The lowering will be 20mm less than indicated

FOR models with a 55mm diameter strut on the front axle.

For vehicles equipped with electronically controlled suspension, the disconnection box is required. Part number 68510370