STXA Coilovers ST Suspensions AUDI A3

STXA Coilovers ST Suspensions for AUDI A3, (8V) without adaptive suspension, incl. Sedan + Sportback, 2WD, models with independent rear suspension (IRS), Ø 55mm struts

Years: 05/12-

Maximum permitted front axle weight (in kg): -980

Maximum permitted rear axle weight (in kg): -990

Front lowering in mm: 30-60

Rear lowering in mm: 30-55

Derived from motorsport, the STXA range allows height AND damping adjustment. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber shaft. For those who need to fine-tune their settings for a personalized setup. Galvanized treatment plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has springs at the rear, the same applies with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut bodies are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please contact us via the contact form.

Technical note to consider before ordering:

ON M-Tech equipped models, only use lowering springs kits. Lowering will be 20mm less than indicated

FOR models with 55mm diameter strut on the front axle.

For vehicles equipped with electronically controlled suspension, the disconnect box is required. Part number 68510370