STXA coilovers ST Suspensions AUDI A1 / AUDI A1 Sportback / SEAT Ibiza V / SKODA Fabia II / VOLKSWAGEN Polo IX

Years: 08/10-

Maximum permitted weight on front axle (kg): -900

Maximum permitted weight on rear axle (kg): -840

Front lowering (mm): 15-50

Rear lowering (mm): 15-50

Derived from motorsport, the STXA range allows adjustment of BOTH ride height AND damping. Height adjustment at the front and rear (on vehicles that allow it) via a ring located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber shaft. For anyone who needs to fine-tune their setup for a personalized "setup". Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as standard, the same applies with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut assemblies are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any further information.

Technical note to consider before ordering:

ON models fitted with M-Tech, only use the lowering spring kits. The lowering will be 20mm less than the figure indicated