STX Threaded Coilovers ST Suspensions VOLKSWAGEN Passat B5

Years: 10/96-

Maximum permitted front axle load (in kg): -1100

Maximum permitted rear axle load (in kg): -1080

Front lowering in mm: 40-75

Rear lowering in mm: 40-75

Derived from motorsport, the STX range offers ultra-precise ride height adjustment while benefiting from a factory-set fixed damping setting. Ride height adjustment on the front and rear (where the vehicle allows) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if you only have springs at the rear as original equipment, the same applies with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For all other models, please make sure you equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Please use the contact form for any other information.

Technical note to consider before ordering:

EXCEPT 4-wheel drive.

Damping adjustment is possible by removing the shock absorber or by modifying the rear male trim to access the top of the shock absorber.