STX Threaded Coilovers ST Suspensions VOLKSWAGEN Golf VI

Years: 10/08-

Maximum permitted front axle load (in Kg): 1106-1170

Maximum permitted rear axle load (in Kg): -1000

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX range offers ultra-precise height adjustment while benefiting from a factory-set fixed damping rate. Height adjustment at the front and rear (where the vehicle allows it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for enhanced longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if you only have original rear springs, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Feel free to contact us via the contact form for any other information.

Technical note to consider before ordering:

EXCEPT 4-wheel drive.

FOR models with 55 mm strut diameter on the front axle.

For vehicles equipped with DDC controlled suspension, make sure it is properly disconnected. A disconnection kit is available under KW REF 68510141 in the KW accessories range.