STX Threaded Coilovers ST Suspensions VOLKSWAGEN Golf VI

Years: 10/08-

Maximum permitted front axle weight (in kg): 1036-1105

Maximum permitted rear axle weight (in kg): -1000

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX range offers ultra-precise height adjustment along with a factory-set fixed damping. Height adjustment on the front and rear (for vehicles that allow it) via a dial located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspension kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

For any other information, please contact us using the contact form.

Technical note to consider before ordering:

EXCEPT 4WD.

FOR models with 50mm diameter strut on the front axle.

For vehicles equipped with DDC electronically controlled suspension, check that it is properly disconnected. You can find a disconnection kit in the KW accessory range, REF 68510141.