STX threaded coilovers ST Suspensions SEAT Leon III

Years: 11/12-

Maximum permitted front axle weight (kg): 966-1065

Maximum permitted rear axle weight (kg): -1050

Front lowering (mm): 35-65

Rear lowering (mm): 35-65

Derived from motorsport, the STX range offers ultra-precise ride height adjustment while benefiting from a factory-set fixed damping rate. Front and rear ride height adjustment (where the vehicle allows) via a disc located on the threaded body of the shock. Galvanized finish plus anti-corrosion coating for enhanced longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has springs at the rear, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any further information, please contact us using the contact form.

Technical note to consider before ordering:

FOR models with 50mm diameter front struts.

The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.