STX threaded coilovers ST Suspensions SEAT Leon III

Years: 11/13-

Maximum permitted front axle load (kg): 966-1090

Maximum permitted rear axle load (kg): -1050

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX range offers ultra-precise height adjustment while benefiting from a factory-set fixed damping adjustment. Height adjustment at the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They install in place of the original suspension without modification. For example, if the original setup only has springs at the rear, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any further information.

Technical note to consider before ordering:

FOR models with 55mm diameter strut on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under reference KW 68510342.