STX threaded coilovers ST Suspensions OPEL Vectra B

Years: 10/95-

Maximum permitted front axle load (in Kg): -950

Maximum permitted rear axle load (in Kg): -1025

Front lowering in mm: 35-75

Rear lowering in mm: 35-75

Derived from motorsport, the STX range allows ultra-precise ride height adjustment while benefiting from a fixed damping setting set at the factory. Ride height adjustment at the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They install in place of the original suspension, without modification. If, for example, you only have springs at the rear as original equipment, the same will apply to these ST Suspension kits.

The only models sold with strut mounts are STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any further information, please contact us using the contact form.

Technical note to consider before ordering:

EXCEPT models equipped with level control (or level control adjustment required).