STX Threaded Coilovers ST Suspensions BMW 5 Series

Years: 06/04-

Maximum permitted front axle load (in kg): -1070

Maximum permitted rear axle load (in kg): -1300

Front lowering in mm: 25-45

Rear lowering in mm: 25-45

Derived from motorsport, the STX range offers ultra-precise ride height adjustment while benefiting from a fixed damping setting set at the factory. Ride height adjustment on the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized treatment plus anti-corrosion coating to ensure increased longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to fit the vehicle. They replace the original suspension without modification. For example, if the original setup only has springs at the rear, the same will apply to these ST Suspension kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Please use our contact form for any further information.

Technical note to consider before ordering:

Installation may require wheel spacers.

Rear: sport shock absorbers and the sensor connection kit for the ride height sensors are supplied. The original air spring is retained. For height adjustment, refer to the installation manual.