STX Threaded Coilovers ST Suspensions BMW 5 Series

Years: 01/97-

Maximum permitted weight on front axle (in Kg): 1021-1095

Maximum permitted weight on rear axle (in Kg): -1410

Front lowering in mm: 35-65

Rear lowering in mm: 30-60

Derived from motorsport, the STX range offers ultra-precise height adjustment with a factory-set fixed damping. Height adjustment on front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock. Galvanized finish plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Strut legs are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any other information, please use our contact form.

Technical note to consider before ordering:

For models equipped with the EDC system (electronic damping control)

, the following parts must be replaced: Front: bearing: REF. BMW 31 331 091 709 + strut mount: REF. BMW 31 331 116 983 + dust boot: REF. BMW 31 331 110 196. Rear: upper bearing REF. BMW 33 521 091 710 + bracket: REF BMW 33 521 090 282 + spring seat: REF BMW 33 521 092 986 + dust boot: REF BMW 31 331 137 932 + rubber washer: REF BMW 33 531 091 031.