STX threaded coilovers ST Suspensions AUDI A3 / SEAT Leon III / SKODA Octavia III / VOLKSWAGEN Golf VII

STX ST Suspensions coilovers for AUDI A3, (8V) without electronically controlled suspension, incl. saloon + Sportback, 2-wheel drive, only vehicles with rigid rear axle, Ø 50mm struts

Years: 05/12-

Maximum permitted front axle load (kg): -980

Maximum permitted rear axle load (kg): -1050

Front lowering (mm): 30-60

Rear lowering (mm): 30-55

Derived from motorsport, the STX range offers ultra-precise ride height adjustment while benefiting from a fixed damping setting set at the factory. Ride height adjustment at the front and rear (where the vehicle allows it) via a disc located on the shock absorber threaded body. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has rear springs, the same will apply to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please remember to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential to lowering is required. The strut bodies are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Please use the contact form for any other information.

Technical note to consider before ordering:

ON M-Tech equipped models, only use lowering spring kits. Lowering will be 20mm less than indicated

FOR models with 50mm diameter strut on the front axle.

For vehicles equipped with electronically controlled suspension, the disconnect box is required. Part number 68510370