STX Threaded Coilovers ST Suspensions AUDI A3

STX coilovers from ST Suspensions for AUDI A3, (8V) without adaptive suspension, incl. Sedan + Sportback, 2WD, models with independent rear suspension (IRS), Ø 55mm struts

Years: 05/12-

Maximum permitted front axle weight (kg): 981-1075

Maximum permitted rear axle weight (kg): -990

Front lowering (mm): 30-60

Rear lowering (mm): 30-55

Derived from motorsport, the STX range offers ultra-precise height adjustment along with a factory-set fixed damping stiffness. Height adjustment at the front and rear (where the vehicle permits it) via an adjustment ring located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in the quantity needed to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has springs at the rear, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut bodies are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please use our contact form.

Technical note to consider before ordering:

On M-Tech models, only use the lowering spring kits. The lowering will be 20 mm less than the value indicated

FOR models with 55mm diameter struts on the front axle.

For vehicles equipped with adaptive suspension, the disconnect box is required. Part number 68510370