STX ST Suspensions Coilovers DODGE Challenger 2

Years: MY 11-

Maximum permitted front axle load (in Kg): -1275

Maximum permitted rear axle load (in Kg): -1275

Front lowering in mm: 30-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX range allows ultra-precise height adjustment while benefiting from a factory-set fixed damping firmness. Ride height adjustment at the front and rear (where the vehicle allows) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in the quantity needed to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as standard, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please remember to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Strut bodies are galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any further information, please contact us using the contact form.

Technical note to consider before ordering:

The factory electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510314.