STX ST Suspensions Coilovers AUDI A3

STX ST Suspensions coilovers for AUDI A3, (8V) without adaptive suspension incl. saloon + Sportback, all-wheel drive, Ø 50mm strut diameter, models with independent rear suspension (IRS)

Years: 05/12-

Maximum permitted front axle load (in kg): -1100

Maximum permitted rear axle load (in kg): -1040

Front lowering in mm: 30-60

Rear lowering in mm: 30-55

Derived from motorsport, the STX range offers ultra-precise ride height adjustment, while benefiting from a fixed damping setting set at the factory. Ride height adjustment on the front and rear (where the vehicle allows it) via a collar located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut sleeves are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any further information, please contact us using the contact form.

Technical note to consider before ordering:

ON vehicles equipped with M-Tech, only use the lowering spring kits. The lowering will be 20mm less than the value indicated

FOR models with a Ø 50mm strut on the front axle.

For vehicles equipped with adaptive suspension, the disconnect box is required. Part number 68510370