STX Coilovers ST Suspensions VOLKSWAGEN Sharan III

Years: 09/10-

Maximum permitted front axle load (in Kg): -1320

Maximum permitted rear axle load (in Kg): -1340

Front lowering in mm: 25-50

Rear lowering in mm: 35-60

Derived from motorsport, the STX range offers ultra-precise height adjustment while benefiting from a factory-set fixed damping. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anticorrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has springs at the rear, the same will apply with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

FOR models with 55mm diameter strut on the front axle.

For vehicles fitted with DDC electronically controlled suspension, make sure they are properly disconnected. You can find a disconnection kit, REF 68510141, in the KW accessory range.