STX Coilovers ST Suspensions VOLKSWAGEN Scirocco

Years: 12/09-

Maximum permitted front axle weight (in Kg): 1001-1090

Maximum permitted rear axle weight (in Kg): -780

Front lowering in mm: 10-45

Rear lowering in mm: 10-45

Derived from motorsport, the STX range offers ultra-precise height adjustment, while benefiting from a factory-set fixed damping rate. Height adjustment on front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, this will also be the case with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspension kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

FOR models with 55mm diameter strut on the front axle.

If maximum lowering is applied, the turn signals and parking lights must be relocated (body height too low for TÜV, STVZ0 standard).

For vehicles equipped with DDC electronically controlled suspension, check that it is properly disconnected. You can find a disconnection kit in the KW accessories range, REF 68510141.