STX Coilovers ST Suspensions VOLKSWAGEN New Beetle I

Years: 01/03-

Maximum permitted front axle weight (in kg): -1030

Maximum permitted rear axle weight (in kg): -850

Front lowering in mm: 25-55

Rear lowering in mm: 25-55

Derived from motorsport, the STX range offers ultra-precise height adjustment, with a factory-set fixed damping. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized treatment plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same will apply with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to use original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please contact us using the contact form.

Technical note to consider before ordering:

Installation may require wheel spacers.

For models with 50mm diameter, it is strongly recommended to replace the original sway bar to avoid any contact with the right-hand driveshaft, use sway bar 66550008 (to be ordered separately). (91)

In case of extreme lowering, it is strongly recommended to replace the sway bar to avoid any contact with the right-hand driveshaft. If the vehicle is not fitted with Xenon headlights, use sway bar REF. 685 50 000; if fitted with Xenon headlights, use sway bar REF. 685 50 005