STX Coilovers ST Suspensions VOLKSWAGEN New Beetle I

Years: 01/98-

Maximum permitted front axle load (in kg): -1030

Maximum permitted rear axle load (in kg): -850

Front lowering in mm: 35-60

Rear lowering in mm: 30-60

Derived from motorsport, the STX range allows ultra-precise height adjustment while benefiting from a fixed damping setting made at the factory. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized and anti-corrosion coated for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has rear springs originally, this will also be the case with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential to lowering is required. Strut assemblies are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

For any other information, feel free to contact us via the contact form.

Technical note to consider before ordering:

Fitting may require wheel spacers.

For 50mm diameter models, it is strongly recommended to replace the original sway bar to avoid any contact with the right-hand axle shaft. Use sway bar 66550008 (to be ordered separately). (91)

For extreme lowering, it is strongly recommended to replace the sway bar to avoid any contact with the right-hand axle shaft. If the vehicle has no Xenon headlights, use sway bar REF. 685 50 000. If the vehicle has Xenon headlights, use sway bar REF. 685 50 005.