STX Coilovers ST Suspensions VOLKSWAGEN Jetta II

Years: 8/83 to 12/92

Maximum permitted front axle weight (in Kg): -840

Maximum permitted rear axle weight (in Kg): -740

Front lowering in mm: 45-85

Rear lowering in mm: 45-85

Derived from motorsport, the STX range allows ultra-precise height adjustment while benefiting from a factory-set fixed damping adjustment. Height adjustment at the front and rear (on vehicles that allow it) via a ring located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They replace the original suspension without modification. For example, if the original setup only has springs at the rear, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to use the original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut tubes are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please contact us via the contact form.

Technical note to consider before ordering:

EXCEPT 4WD.