STX coilovers ST Suspensions VOLKSWAGEN Golf VII 4Motion

Years: 11/12-

Maximum permitted front axle load (in kg): -1080

Maximum permitted rear axle load (in kg): -980

Front lowering in mm: 35-65

Rear lowering in mm: 40-65

Derived from motorsport, the STX range allows ultra-precise height adjustment while retaining a factory-set fixed damping. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has springs at the rear, the same will apply to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. Strut legs are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

Please use our contact form for any further information.

Technical note to consider before ordering:

On vehicles fitted with M-Tech, use only lowering springs. Lowering will be 20mm less than indicated

FOR models with a 55mm diameter strut on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under reference KW 68510342.