STX Coilovers ST Suspensions VOLKSWAGEN Golf VII

Years: 11/12-

Maximum permitted front axle load (in kg): 966-1065

Maximum permitted rear axle load (in kg): -1050

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX range offers ultra-precise ride height adjustment while benefiting from a factory-set fixed damping rate. Height adjustment on the front and rear (where the vehicle allows it) via a disc located on the threaded body of the shock absorber. Galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies with these ST Suspension kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

ON M-Tech equipped models, only use the lowering spring kits. The lowering will be 20mm less than indicated

FOR models with 50mm diameter struts on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under KW reference 68510342.