STX Coilovers ST Suspensions SEAT Toledo II / SKODA Octavia I / VOLKSWAGEN Bora / VOLKSWAGEN Golf IV

Years: 04/99-

Maximum permitted front axle load (in kg): -1020

Maximum permitted rear axle load (in kg): -1020

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX range offers ultra-precise height adjustment while benefiting from a fixed damping setting factory-set. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup only has springs at the rear, this will also be the case with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut tubes are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please feel free to contact us using the contact form.

Technical note to consider before ordering:

Installation may require wheel spacers.

For models with 50 mm diameter, it is strongly recommended to replace the original sway bar to prevent any contact with the right-hand axle shaft. Use sway bar 66550008 (to be ordered separately). (91)

In case of extreme lowering, it is strongly recommended to replace the sway bar to prevent any contact with the right-hand axle shaft. For versions without xenon headlights, use sway bar REF. 685 50 000. For versions with xenon headlights, use sway bar REF. 685 50 005.